To Next Page

To Previous Page

GUI reference

R&S

ZNB/ZNBT

795User Manual 1173.9163.02 ─ 62

Remote command:

SYSTem:COMMunicate:RDEVice:SMATrix<Matr>:DEFine

SYSTem:COMMunicate:RDEVice:SMATrix<Matr>:SERial?

Delete All

Unregisters all switch matrices, automatically deleting all switch matrix RF connections.

Remote command:

SYSTem:COMMunicate:RDEVice:SMATrix:DELete

5.18.5.4 Device LAN Configuration dialog

The "Device LAN Configuration" dialog allows you to read and to modify the "IP Config-

uration" of an external device that is equipped with a LAN interface.

Access: External Matrices dialog > "Configure"

Because the IP configuration is written to the device, the device must be online for the

settings to be applied.

Uncheck "Manual Configuration" if you want the device to discover its host configura-

tion via DHCP. In this case only the device's "Hostname" can be specified.

In "Manual Configuration" mode also the unit's "IP Address", "Subnet Mask" and "Stan-

dard Gateway" can be set. If the unit is located in the same subnet as the analyzer,

simply use "Copy from local network" to copy the "Subnet Mask" and "Standard Gate-

way" from the analyzer's IP settings.

Setup softtool

R&S ZNB Series User Manual

Questions and Answers: