R&S ZNB Series - Page 1407

Command reference
R&S
®
ZNB/ZNBT
1407User Manual 1173.9163.02 ─ 62
Example: See SYSTem:COMMunicate:RDEVice:SMATrix:
CONFigure:STARt
Usage: Event
Manual operation: See "Delete All" on page 795
SYSTem:COMMunicate:RDEVice:SMATrix<Matr>:RELays:SWITch:COUNt?
For mechanical matrices, this command allows to query the list of switch counts for all
relays (if supported by the matrix).
Suffix:
<Matr>
.
Index of the switch matrix (see SYSTem:COMMunicate:
RDEVice:SMATrix<Matr>:DEFine on page 1405)
Usage: Query only
Manual operation: See "Configured External Switch Matrices" on page 769
SYSTem:COMMunicate:RDEVice:SMATrix:SCAN?
Scans for external switch matrices connected via USB or Direct Control.
Returns a comma-separated list
<Driver_1>,<Interface_1>,<Address_1>,...,<Driver_N>,
<Interface_N>,<Address_N>, one triple
<Driver_n>,<Interface_n>,<Address_n> for each detected switch matrix
<Matr>=1,...,N.
Use SYSTem:COMMunicate:RDEVice:SMATrix<Matr>:DEFine to configure them.
Usage:
Query only
Manual operation: See "Scan Instruments" on page 793
SYSTem:COMMunicate:RDEVice:SMATrix<Matr>:SERial?
Returns the serial number of the related switch matrix.
Suffix:
<Matr>
.
Index of the switch matrix (see SYSTem:COMMunicate:
RDEVice:SMATrix<Matr>:DEFine on page 1405)
If the switch matrix is not part of the RF configuration, the query
returns an "Invalid suffix" error.
Usage: Query only
Manual operation: See "Configured Devices" on page 793
SCPI command reference