R&S ZNB Series User Manual

GUI reference
R&S
®
ZNB/ZNBT
312User Manual 1173.9163.02 ─ 62
DUT
Balanced
port
Balanced
port
Log.
NWA
port
Physical port c
Logical ports j,k
(single-ended)
Physical port d
Logical port i
(balanced)
Physical port a
Physical port b
Imbalance 1 / Imbalance 2
Imbalance 1 selects the balanced logical port i as the input, the single-ended logical
ports j and k as the output and calculates the following imbalance parameter:
Imb
jk-i
= –(S
ca
– S
da
)/(S
cb
– S
db
)
Imbalance 2 selects the balanced logical port i as the output, the single-ended logical
ports j and k as the input and calculates the following imbalance parameter:
Imb
i-jk
= –(S
ac
– S
ad
)/(S
bc
– S
bd
)
Remote command:
CALCulate<Ch>:PARameter:MEASure "<Trace_Name>", "IMB<i>-<j><k>"
| "IMB<j><k>-<i>"
CALCulate<Ch>:PARameter:SDEFine "<Trace_Name>", "IMB<i>-<j><k>"
| "IMB<j><k>-<i>"
5.2.9 Stability tab
Selects one of the three two port stability factors K, μ
1
or μ
2
as measured quantities. A
typical application of stability factors is to assess the stability of an amplifier. Stability
factors cannot be calculated in balanced port configurations.
Background information
Refer to Chapter 4.3.7, "Stability factors", on page 142.
Meas softtool

R&S ZNB Series Specifications

General

Brand	R&S
Model	ZNB Series
Category	Measuring Instruments
Language	English