R&S ZNB Series - 7.3.15.1 SOURce:FREQuency...

Command reference
R&S
®
ZNB/ZNBT
1332User Manual 1173.9163.02 ─ 62
Port-specific and general settings
The SOURce... subsystem comprises channel-specific and general settings. Chan-
nel-specific settings are valid for the channel specified by the numeric suffix <Ch>
(SENSe<Ch>:...). General settings are valid for all channels; the channel suffix is
ignored. Refer to the description of the individual commands for more information.
7.3.15.1 SOURce:FREQuency...
The SOURce:FREQuency... commands configure the sources for frequency conver-
sion measurements and control the frequency and power of the internal signal source.
SOURce<Ch>:FREQuency<PhyPt>:CONVersion:ARBitrary:EFRequency<Gen>............... 1332
SOURce<Ch>:FREQuency<PhyPt>:CONVersion:ARBitrary:IFRequency...........................1334
SOURce<Ch>:FREQuency:CONVersion:MIXer:PMFixed.................................................1335
SOURce<Ch>:FREQuency:CONVersion:MIXer:PMODe.................................................. 1336
SOURce<Ch>:FREQuency<PhyPt>[:CW]...................................................................... 1336
SOURce<Ch>:FREQuency<PhyPt>:FIXed..................................................................... 1336
SOURce<Ch>:FREQuency<PhyPt>:CONVersion:ARBitrary:EFRequency<Gen>
<Boolean>, <Numerator>, <Denominator>, <Offset>, <SweepType>
Defines an external generator frequency for frequency-converting measurements. The
external generator frequency is either a range (for frequency sweeps) or a CW fre-
quency (for power, time and CW Mode sweeps).
Suffix:
<Ch>
.
Channel number
<PhyPt> Test port number of the analyzer. This suffix is ignored because
the generator is referenced via <Gen>.
<Gen> Generator number
Parameters:
<Boolean> Switch the generator on or off.
SCPI command reference