R&S ZNB Series - 7.3.10 MEMory commands

Command reference
R&S
®
ZNB/ZNBT
1136User Manual 1173.9163.02 ─ 62
0 (query) – no RF connection to a switch matrix
Example: See SYSTem:COMMunicate:RDEVice:SMATrix:
CONFigure:STARt
INSTrument:TPORt:COUNt?
Returns the total number of test ports.
In absence of switch matrices, i.e. if no RF connection to a switch matrix is configured,
this is identical to the number of VNA ports (see INSTrument:PORT:COUNt?).
With switch matrices, the return value is the total number of matrix test ports plus the
number of VNA ports that are not connected to a switch matrix.
Usage:
Query only
7.3.10
MEMory commands
The MEMory... commands control the loaded recall sets of the analyzer.
Storing setups
The MEMory... commands do not affect any stored files. Use the MMEMory... com-
mands to store and load data and to manage files stored on a mass storage device.
MEMory:CATalog?........................................................................................................1136
MEMory:CATalog:COUNt?............................................................................................ 1137
MEMory:DEFine...........................................................................................................1137
MEMory:DELete:ALL.................................................................................................... 1137
MEMory:DELete[:NAME]...............................................................................................1137
MEMory:SELect........................................................................................................... 1137
MEMory:CATalog?
Returns the names of all loaded recall sets.
Example:
*RST; :MEM:DEF 'SET_2'
Create a recall set named 'Set_2' and make it the active recall
set.
MEM:CAT?
Query all recall sets. The response is 'Set1,SET_2'.
MMEM:STOR:STAT 1, 'C:\Users\Public\
Documents\Rohde-Schwarz\Vna\RecallSets\Set_2.znx'
MEM:DEL 'Set_2.znx'
Store the active recall set "Set_2" to a file, renaming it
"Set_2.znx". Close the setup.
Usage: Query only
SCPI command reference