R&S ZNB Series - 7.3.1.9 CALCulate:MATH...

Command reference
R&S
®
ZNB/ZNBT
963User Manual 1173.9163.02 ─ 62
Parameters:
<ResponseValue> Setting (ARBitrary mode only): sets the vertical position of the
marker in Y units of the current trace format.
Query: returns the marker position formatted according to the
current marker format (see CALCulate<Chn>:MARKer<Mk>:
FORMat or CALCulate<Chn>:MARKer<Mk>:REFerence:
FORMat), i.e. as displayed in the marker info field (1 return value
per row in the response column). Indetermined result values are
returned as a sequence of dashes (------). This may occur in
ARBitrary mode, if the transformation between trace format and
marker format requires a concrete stimulus value.
Default unit: NN
Example: Suppose that the active recall set contains an active trace no. 1.
CALC:MARK ON
Create marker no. 1 and display it in the center of the sweep
range.
CALC:MARK:Y?
Query the measurement value at the marker position.
CALC:MARK:STAT:AREA LEFT, TOP
For a subsequent check at the GUI or a hardcopy, move the info
field to the top left position.
Manual operation: See "Mkr <i> Arb. Response / Ref Mkr Arb. Response"
on page 392
7.3.1.9 CALCulate:MATH...
The CALCulate:MATH... commands permit processing of measured data in numeri-
cal expression format. The operators are +, -, *, / and use of constants and data arrays
are permitted.
CALCulate<Chn>:MATH[:EXPRession]:SDEFine.............................................................. 963
CALCulate<Chn>:MATH:FORMatted[:EXPRession]:SDEFine.............................................963
CALCulate<Chn>:MATH:FUNCtion..................................................................................965
CALCulate<Chn>:MATH:FORMatted:FUNCtion................................................................ 965
CALCulate<Chn>:MATH:MEMorize..................................................................................965
CALCulate<Chn>:MATH:STATe.......................................................................................966
CALCulate<Chn>:MATH:FORMatted:STATe..................................................................... 966
CALCulate<Chn>:MATH:WUNit[:STATe]...........................................................................967
CALCulate<Chn>:MATH[:EXPRession]:SDEFine <Expression>
CALCulate<Chn>:MATH:FORMatted[:EXPRession]:SDEFine <Expression>
Defines a mathematical trace for the active trace, using a string expression.
●
The expression in the first command refers to raw, unformatted trace data (complex
data). In order to apply it, CALCulate<Chn>:MATH:FUNCtion must be set to
NORMal and CALCulate<Chn>:MATH:STATe must be set to ON.
SCPI command reference