R&S ZNB Series - Page 392

GUI reference
R&S
®
ZNB/ZNBT
392User Manual 1173.9163.02 ─ 62
Mkr <i> Stimulus / Ref Mkr Stimulus
Gets/sets the stimulus value of the active marker.
Remote command:
CALCulate<Chn>:MARKer<Mk>:X
CALCulate<Chn>:MARKer<Mk>:REFerence:X
Mkr <i> Arb. Response / Ref Mkr Arb. Response
Gets/sets the response value (Y position) of an "Arbitrary" marker (see "Marker Mode"
on page 395).
Remote command:
CALCulate<Chn>:MARKer<Mk>:Y
CALCulate<Chn>:MARKer<Mk>:REFerence:Y
On
Enables/disables the active marker.
Markers remember their "Marker Props" while disabled (see Chapter 5.7.2, "Marker
Props tab", on page 394). The marker properties are definitely lost when the associ-
ated trace is deleted.
Remote command:
CALCulate<Chn>:MARKer<Mk>[:STATe]
CALCulate<Chn>:MARKer<Mk>:REFerence[:STATe]
All Off
Disables all markers of the active trace.
Markers remember their "Marker Props" while disabled (see Chapter 5.7.2, "Marker
Props tab", on page 394). The marker properties are definitely lost when the associ-
ated trace is deleted.
Marker softtool