R&S ZNB Series User Manual

Concepts and features
R&S
®
ZNB/ZNBT
128User Manual 1173.9163.02 ─ 62
Redefining physical ports can be used to insert external components (e.g. external sig-
nal separating devices, power amplifiers etc.) into the signal path. This allows you to
develop custom measurements, e.g. to test high-power devices and extend the
dynamic range.
Amp
Ext
Gen 1
VNA
21
Dual
Directional Coupler
DUT
Redefined Physical Port 1
a wave: b
1
b wave: b
2
Source: Ext Gen 1
Figure 4-6: Redefined physical port 1 (port 2 not used)
Amp
VNA
32
coupler
DUT
Redefined Physical Port 1
a wave: b
2
b wave: b
3
Source: Port 1
Redefined Physical Port 2
a wave: a
4
b wave: b
4
Source: Port 4
1 4
Figure 4-7: Two redefined ports
High Signal Power
When dealing with external signal amplification, make sure that:
●
the signals fed to the analyzer are within the allowed range
●
during calibration the calibration standards meet the requirements in terms of their
power handling capacity
Attenuator pads can be used to adapt the power levels.
4.3.2 Reference impedances
Changing the reference impedances of the analyzer ports is often referred to as
renormalization of port impedances. Renormalization means that the measurement
results measured at 50 Ω (75 Ω) are converted into results at arbitrary port impedance.
●
Renormalization of the physical port impedances affects, e.g., S-parameters and
wave quantities in "Power" representation.
Measurement results

R&S ZNB Series Specifications

General

Brand	R&S
Model	ZNB Series
Category	Measuring Instruments
Language	English