GUI reference
R&S
®
ZNB/ZNBT
677User Manual 1173.9163.02 ─ 62
5.14.6 More tab
The buttons on the "More" tab allow you to load simulation data or close the VNA appli-
cation.
Loading simulation data is only available for the PC firmware simulation (see Chap-
ter 4.7.31, "R&S ZNXSIM", on page 278).
Load Simulation Data...
Imports simulation data into the current setup.
The analyzer opens the "Load Simulation Data" dialog that lets you select a trace file
(*.sNp, *.csv, *.dat). As an option, you can load the simulation data into the
"Active Channel Only", allowing you to analyze different simulation data in different
channels of a setup.
Tip: Using the standard trace file export functionality, the loaded data can be converted
to different formats.
Config Additional Simulation Data...
Allows you to import port-specific simulation data into the current channel (firmware
simulation only; see Chapter 4.7.31.1, "Simulation data", on page 279).
Opens the Configure Additional Simulation Data dialog.
Simulation Noise
Allows you to add random noise to the loaded simulation data to let the traces appear
more "realistic" (see Chapter 4.7.31.2, "Simulation noise", on page 280). By default,
"Simulation Noise" is inactive.
File softtool
To Next Page
Loading...
