Bit Switches
D356 92 SM
I-fax Switch 03 (SP No. 1-102-004)
No Function Comments
Original Output at Transfer Station
0
This setting determines whether the original is output at the transfer station when
it is received from the sender that initiated the transfer transmission. This feature
is the same as for G3 transfer transmissions.
0: Received original not output at the transfer station.
1: Received original output. The original is printed after the transfer station has
transferred it to the destinations, so its output confirms that the original has been
transferred.
Transfer Result Report
1
This setting determines when a Transfer Result Report is generated and returned
to the transfer requestor.
0: Returns the report after each transfer.
1: Returns the report only if an error occurred during transfer.
Destination Error Handling for Reception Transfer Request
2
This setting restricts transfer transmission based on whether the final destinations
are correct or not.
0: The transfer station transmits to correct destinations only (addresses with no
errors in them).
1: If any address has an error in it, the transfer station transfers no transmissions
and returns a transfer transmission failure report to the requestor that initiated the
transfer.
There is no negotiation between the transfer initiator and the transfer station to
determine whether the final destination addresses are correct or not. This setting
determines whether or not the transfer station transfers the transmissions if there
is a mistake in even one of the final destination addresses.
To Next Page
Loading...
