Ricoh D014 - Before You Begin the Procedure; Hdd Encryption Unit

MFP Controller Options
SM 1-165 D014/D015/D078/D079
Installation
1.18.12 HDD ENCRYPTION UNIT
Before You Begin the Procedure
1. Make sure that the following settings are not at the factory default settings:
 Supervisor login password
 Administrator login name
 Administrator login password
 These settings must be set up by the customer before the encryption option
can be installed.
2. Confirm that "Admin. Authentication" is on:
[User Tools]> "System Settings"> "Administrator Tools"> "Administrator Authentication
Management"> "Admin. Authentication"> "On"
If this setting is "Off" tell the customer that this setting must be "On" before you can do
the installation procedure.
3. Confirm that "Administrator Tools" is selected and enabled:
[User Tools]> "System Settings"> "Administrator Tools"> "Administrator Authentication
Management"> "Available Settings
 "Available Settings" is not displayed until "Admin. Authentication" is switch on.
If this setting is not selected tell the customer that this setting must be selected before
you can do the installation procedure.
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA