MFP Controller Options
SM 1-155 D014/D015/D078/D079
Installation
14. Turn the copier off again, then:
Reattach the SD card slot cover.
Remove the cover from the front door, and store the SD card that was copied.
(See "Storing SD Application Cards on Site" in this section)
The SD card must be stored with the machine for these reasons:
Once an SD card has been copied, it can no longer be used. But it must be stored in
the front door to serve as proof of purchase by the customer.
Also, at a later time the stored SD cards can be restored to full use with SP5873-2
(described in the next section).
Before you put the card in the front cover, label it so that it can be easily identified.
Undo Exec
1. Turn the main switch off.
2. Put the SD card with the applications in the Slot 2 (upper slot).
3. Put the original destination SD card (the one stored in the front door) into the Slot 1
(lower slot).
The SD card in Slot 1 (lower slot) must be the original SD card of the
application you want to move from Slot 2 (upper slot) to Slot 1 (lower slot).
You cannot use any blank SD card in Slot 1 (lower slot). The application will
be moved only to the original SD card.
4. Turn the main switch on.
5. Go into the SP mode and do SP5873-2 (Undo Exec)
6. Follow the messages on the operation panel to complete the procedure.
7. Turn the main switch off.
8. Remove the SD cards from the slots.
9. Turn the main switch on.
⇒
Rev. 04/13/2009
To Next Page
Loading...
