Ricoh D014 - Sp Setting

Firmware Udate
D014/D015/D078/D079 1-110 SM
 Never switch off the machine while the update is in progress.
9. After asterisks have replaced all the hyphens in the progress bar, switch off the
machine.
10. Remove the SD card from the SD card slot and reattach the SD card slot cover.
11. Close the front door.
12. Switch on the machine.
13. Enter the SP mode and do SP5990-5 to print the self-diagnostic report.
14. Confirm that the finisher firmware updated successfully.
 For "Finisher 1", you should see the numbers that you saw for the NEW column in
the initial screen at Step 6.
 If you see these numbers, the update has executed successfully.
 If the update fails, turn the machine off and try the procedure again.
15. Switch the machine off and remove the SD card.
16. Switch the machine on.
This completes the firmware update procedure.
1.13.7 SP SETTING
1. Enter the SP mode.
2. Do SP5841-12 and enter the name of the staples used for corner stapling.
 This is the name that shows when the user prints the Inquiry List.
 To print this list push User Tools> [Inquiry]> [Print Inquiry List]> [Start].
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA