2000/3000 Sheet Finishers (D373/D374)
D014/D015/D078/D079 1-84 SM
Selecting the Staple Supply Name
Go into the SP mode and input this information.
5841
Supply Name
Setting
These names show when the user prints the Inquiry List Push
the Counter key, then push 'Print Inquiry List'. Push the
Inquiry button on the initial User Tools screen.
013 Staple Std3
Input the name of the staples that are used for standard
stapling (not booklet stapling). This setting should be done for
the D373 and D374.
022 Staple Bind2
Input the name of the staples that are used for booklet
stapling (saddle-stitching). This setting is necessary only for
the D373.
Enabling Booklet Binding (D373 Only)
To use booklet stapling, you must make sure that the center-position stapling option is
displayed. If it is not, select the center-position stapling mode with a user tool.
1. Push the User Tools key.
2. Touch "Copier/Document Server Features".
3. Touch the "Input/Output" tab.
4. Select "Staple Position".
5. Touch a "Staple Position" button and touch the center (saddle-stitch) stapling symbol.
6. Go out from the User Tools mode. Set the number of copies, touch the center stapling
symbol on the operation panel, then start the print job.
To Next Page
Loading...
