Ricoh D014 - Moving Applications to One Sd Card; Overview; SD Cards

MFP Controller Options
SM 1-153 D014/D015/D078/D079
Installation
SD cards
SD cards are held in position by a small spring-lock mechanism.
1. To install an SD card, push it into the slot until it stops, then release it.
2. To remove an SD card, push the SD card in carefully to release it, and then remove it
from the slot.
1.18.6 MOVING APPLICATIONS TO ONE SD CARD
Overview
There are only two SD card slots:
 Upper slot. Insert the application card in this slot. If more than one application is
required, the applications must be moved to one SD card with SP5873-1.
 Lower slot. Insert VM card application in this slot. This slot is also used for firmware
update.
Here are some important points you should keep in mind about SD cards and their
applications:
 The data necessary for authentication is transferred with the application program to the
target SD card.
 Do not use an SD card if it has previously been used with a computer. Correct
operation is not guaranteed if such an SD card is used.
 The SD card is the only evidence that the customer is licensed to use the application
program. The service technician may occasionally need to check the SD card and its
contents to solve problems. Although copied SD cards are disabled for use, they must
be stored in the machine door for future use and reference. (See "Storing SD
Application Cards on Site" in this section)
 A licensing agreement prohibits copying of a PostScript3 SD card. However, you can
move other applications to the PS3 SD card.
 Once an SD card has been used to hold several applications, it should not be used for
any other purpose.
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA