Ricoh D014 - Developer Replacement; Preparation

PCU
D014/D015/D078/D079 3-46 SM
3.4.4 DEVELOPER REPLACEMENT
The developer replacement procedure is the same for the YMC PCUs and the K PCU.
Preparation
1. Spread some paper on a flat surface to hold developer that will be dumped from the
development unit.
2. Remove:
[A] PCU stand from bottom of the machine
[B] Jig
[C] Brown coupling
 The PCU stands for the D014/D015/D078/D079 and B132/B200 copiers are
different. Be sure to use the PCU stand for the D014/D015/D078/D079. If you
use the PCU stand for the B132/B200, this could damage the exposed drum
on the bottom of the PCU.
3. Remove the metal jig [B] and brown coupling [C] from the bottom of the PCU stand.
4. Set the PCU stand on a flat surface.
5. Remove:
 Toner hopper
 Faceplate
 PCU
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA