Installation Requirements
D014/D015/D078/D079 1-2 SM
6. If the installation area has air-conditioners or heaters, put the machine in a location
that agrees with these conditions:
Where there are no sudden temperature changes from low to high, or high to low.
Where it will not be directly exposed to cool air from an air conditioner in the
summer.
Where it will not be directly exposed to reflected heat from a heater in the winter
7. Do not put the machine where it will be exposed to gases that can cause corrosion.
8. Put the copier on a strong and level surface. The front and rear of the machine must be
less than 5 mm (0.2") away from level.
9. Do not put the machine where there could be strong vibrations.
10. Do not connect the machine to the same power source as other electrical devices.
11. The machine can make an electromagnetic field, and this can cause interference with
radio or television reception.
1.1.2 MACHINE LEVEL
1. Front to rear: Less than 5 mm (0.2") away from level
2. Right to left: Less than 5 mm (0.2") away from level
The machine legs can be turned to adjust them up or down, to make the machine level. Put
a carpenter's level on the exposure glass.
1.1.3 MINIMUM SPACE REQUIREMENTS
Put the copier near the power source. Minimum clearance must be as shown below. The
same amount of clearance is necessary when optional peripheral devices are installed.
To Next Page
Loading...
