Differences Between the D014/D015 & B132/B200
SM D-45 D014/D015/D078/D079
CONTROLLER BOARD
The number of board slots has been reduced to three.
The number of SD card slots has been reduced to two. (A system SD card is no longer
required. The system firmware resides on the controller board.)
A new fan has been added to the GW controller board.
SMALL CHANGES
This is a quick summary of small changes in the D014/D015.
Filter Box Cover. There are new filter boxes on the back of the machine. There are
now three filter boxes.
Paper Tray Handles. A new tray handle design has been adopted for the D014/D015.
Also, the shape and operation of the end fence has changed.
Motherboard. There is no motherboard in the D014/D015
Breaker Switch. This machine does not have a breaker switch that requires testing at
installation.
Peltier Unit. The Peltier unit has been removed. The D014/D015 does not have a
Peltier unit.
Paper Feed Unit. A mylar has been added to facilitate feeding thicker paper.
Bypass Tray. The operation of the side fences is much smoother.
Process Control. The number of steps in process control has been reduced. Also,
MUSIC processing and process control adjustment are executed at the same time at
power on, so that the machine enters standby mode within a shorter length of time.
Fans. Fans and ducts have been added on the faceplate that covers the toner supply
unit. This new arrangement keeps the temperature lower. (The new PxP toner has a
much lower melting point.)
Functions disabled during warm-up. These functions have been disabled during
warm-up:
1. SP3820 (Manual Procon)
2. Auto Color Calilbration (User Tools)
3. Color Registration (User Tools)
To Next Page
Loading...
