Service Program Mode
SM 5-1 D014/D015/D078/D079
Service
Tables
5. SERVICE TABLES
5.1 SERVICE PROGRAM MODE
Notation What it means
[range/step]
Example: [–9∼+9/0.1 mm]
The default setting can be adjusted in 0.1mm steps in the range ±9.
Note: The default setting for each SP mode is shown on the screen in
the "Initial" box immediately below the entry box.
DFU
Denotes "Design or Factory Use". Do not change this value.
Japan Only
The feature or item is for Japan only. Do not change this value.
LEF
Long Edge Feed
SEF
Short Edge Feed
Fin3, Fin4
Please ignore. These notations refer to finishers not yet available for
this machine at the present time (Oct 2007).
To Next Page
Loading...
