Differences Between the D014/D015 & B132/B200
SM D-3 D014/D015/D078/D079
The adoption of the PxP toner with its lower melting point means that the machine must be
adequately ventilated to keep the interior of the machine cooler.
1. Development Unit Cooling
A single fan (near the front door) draws in fresh air from outside the machine and
blows it across the heat sink.
An exhaust fan has been added to each development unit to draw hot air away from
the heat sink.
2. The heat pipe panels over the fusing unit have been overhauled.
The number of heat pipes has been increased and they have been rearranged.
The heat sink cooling fan has been replaced with a fan with a more powerful motor
that can move more air.
B132/B200
To Next Page
Loading...
