Service Call Conditions
D014/D015/D078/D079 4-2 SM
If the operator does not touch "Reset"
The next message tells the operator that the machine will reset automatically and that the
previous job was lost and must be started again. After reading the message, the operator
touches "Confirm" on the screen. The next screen shows the number and title of the SC
code, and stops until the operator turns the machine off and on.
If the operator touches "Reset"
If the operator touches "Reset" to bypass the 30-second interval for the machine to reboot,
the machine reboots immediately and the operation panel displays the copy screen.
Do not try to use the operation panel during an automatic reboot. If the Remote
Service System is in use, the SC code is sent immediately to the Service Center
To Next Page
Loading...
