Service Call Tables
D014/D015/D078/D079 4-78 SM
Data Encryption Error 2
SC859
B
These are errors of the HDD Data Encryption Option D377.
8 HDD Check Error
Data conversion was attempted with no HDD unit
present.
Confirm that HDD unit installed correctly
Initialize HDD with SP5832-1
Note: After installation, a new HDD should be
formatted with SP5832-1
9
Power Loss During
Data Conversion
Data conversion stopped before NVRAM/HDD
data was converted.
Format HDD with SP5832-1
10
Data Read
Command Error
More than two illegal DMAC communications
were returned.
HDD defective
Format HDD with SP5832-1
Replace HDD
HDD startup error at main power on
HDD is connected but a driver error is detected.
The driver does not respond with the HDD within 30 s.
SC860 B
HDD is not initialized
Label data is corrupted
Defective HDD
Initialize the HDD with SP5832-001.
HDD re-try failure *GW
SC861 D
At power on with the HDD
detected, power supply to the
HDD is interrupted, after the
HDD is awakened from the
sleep mode, the HDD is not
ready within 30 s.
Harness between HDD and board
disconnected, defective
HDD power connector disconnected
HDD defective
Controller board defective
Rev. 05/2008
⇒
To Next Page
Loading...
