Group 6000
SM 5-245 D014/D015/D078/D079
Service
Tables
6102 Punch Hole Reg 1 Punch B702 for Finishers D373/D374
This SP corrects punch hole alignment by correcting the skew of each by
adjusting the amount of time the finisher entrance roller remains off while the exit
roller of the machine remains on. This buckles the leading edge of the sheet
slightly against the finisher entrance roller while it remains off.
1 A3 SEF
2 B4 SEF
3 A4 SEF
4 A4 LEF
5 B5 SEF
6 B5 LEF
7 DLT SEF
8 LG SEF
9 LT SEF
10 LT LEF
11 12"x18"
12 Custom
[-5~+5/0.25 mm]
+ Value:Increases time finisher entrance roller
remains off.
- Value: Descreases time finisher entrance roller
remains off.
6103 Punch Hole Reg 2 Punch B702 for Finishers D373/D374
This SP determines whether the finisher entrance roller stops to correct skew
when paper enters the finisher.
1 A3 SEF
2 B4 SEF
3 A4 SEF
[0 to 1/1/1]
0: Paper stops for skew correction
1: Paper does not stop
To Next Page
Loading...
