Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
182 Configuration Manual, 10/2015, C79000-G8976-C351-05
Call up the command with the following parameters:
wlan data rate-11abg {show-rates | {{add | del} <rate> | all | none} [basic]}
The parameters have the following meaning:
Shows a list of the available data transmission speeds.
The data transmission speed is assigned to the WLAN interface entered
The data transmission speed is removed from the WLAN interface en-
tered in the <rate> parameter.
All available data transmission speeds are assigned to the WLAN inter-
Only the first available data transmission speed is assigned to the
WLAN interface. The other data transmission rates are deselected.
The data transmission speed entered in the <rate> parameter is de-
clared as "Basic".
The "basic" parameter can only be called in conjunction with the pa-
rameters "add", "del", "all" and "none".
Note
You need to assign at least one data transmission speed and one "
Basic" to the WLAN
The data transmission speeds are assigned to the WLAN interface.
You display the setting with the show wlan data rates command.
You enable the function with the
wlan data rates-11abg selected only command.
You configure the transmission standard with the
wlan mode command.
You can reset the selection to the default setting with the
wlan data rate-11abg defaults
command.
To Next Page
Loading...
Need help?
General
