Siemens SIMATIC NET Configuration Manual

Description
2.2 CLI modes
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
22 Configuration Manual, 10/2015, C79000-G8976-C351-05
Global Configuration mode
In this mode, you can make basic configuration settings. In addition to this, you can also call
up modes for the configuration of special interfaces or functions, for example to configure a
VLAN or a PLUG. You change to this mode by entering
configure terminal in the Privileged
EXEC mode. You exit this mode by entering
end or exit.
Other configuration modes
From the Global Configuration mode, you can change to other configuration modes for
special tasks. These are either general configuration modes (for example line configuration,
interface configuration) or protocol-specific configuration modes (FTP, NTP).

Siemens SIMATIC NET Specifications

General

Category	Industrial Communication Software
Manufacturer	Siemens
Operating Systems	Windows, Linux
Protocols Supported	PROFIBUS, PROFINET, OPC UA
Compatibility	Siemens PLCs, Third-party devices with supported protocols