R&S ZNB Series - Page 36

Getting started
R&S
®
ZNB/ZNBT
36User Manual 1173.9163.02 ─ 62
name of your DNS domain and the IP addresses of the DNS and WINS servers on
your network.
2. For the R&S ZNBT, connect an external monitor, keyboard and mouse.
3. Press the Windows key in the System keypad (R&S ZNB only) or on an external
keyboard to access Windows
®
.
4. Open the "Control Panel" > "Network and Sharing Center" > "Change adapter set-
tings" dialog and right-click the local connection.
Windows 7: open the "Control Panel" > "Network and Internet" > "Network and
Sharing Center" > "Local Area Connection Status" dialog.
5. Select "Properties" and confirm the user account control message, depending on
your current user account.
● If your current account is an administrator account, select "Yes".
● If your account is an account with standard user rights, enter the password of
the administrator account and select "Yes".
Figure 3-1: User Account Control dialog
6. In the "Connection Properties" dialog opened, select "Internet Protocol Version 4
(TCP/IPv4) > Properties" and enter the IP address information.
Preparing for use