GUI reference
R&S
®
ZNB/ZNBT
380User Manual 1173.9163.02 ─ 62
The active trace must be cartesian and the "Format" of the imported trace must be
the same as the "Format" of the active trace.
●
"Import File..." opens a dialog to load a limit line from a trace file (see Chap-
ter 5.5.11, "Trace Data tab", on page 365).
In case the selected file contains more than one trace, another popup dialog lets
you select the adequate one:
Imported traces are polygonal curves with n points and n – 1, where n is the "Number
of Points" of the imported trace (seeChapter 5.10.1, "Sweep Params tab",
on page 423). The n – 1 segments are appended to the current segment table for fur-
ther editing. Existing limit line segments are not overwritten.
Lines softtool
To Next Page
Loading...
