Command reference
R&S
®
ZNB/ZNBT
926User Manual 1173.9163.02 ─ 62
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<StartStim>
<StopStim> Pairs of stimulus values, each pair confining a limit line segment.
See also Chapter 4.4.1.1, "Rules for limit line definition",
on page 145.
If not specified, the units are adjusted to the sweep type of the
active channel ([SENSe<Ch>:]SWEep:TYPE).
Range: Virtually no restriction for limit segments.
*RST: A segment that is created implicitly, e.g. by means
of CALCulate<Ch>:LIMit:UPPer[:DATA] or CALCu-
late<Ch>:LIMit:LOWer[:DATA,], covers the maxi-
mum sweep range of the analyzer.
Example:
*RST; :CALC:LIM:CONT 1 GHZ, 2 GHZ
Select a lin. frequency sweep (default) and define an upper limit
line segment in the stimulus range between 1 GHz and 2 GHz,
using default response values (–40 dB).
CALC:LIM:DISP ON
Show the limit line segment in the active diagram.
Manual operation: See "Segment List" on page 378
CALCulate<Chn>:LIMit:CONTrol:SHIFt <LimShift>
Shifts an existing limit line in horizontal direction. See also Chapter 4.4.1.1, "Rules for
limit line definition", on page 145.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Setting parameters:
<LimShift> Offset value for the limit line
Range: Virtually no restriction for limit segments
Default unit: NN
Example:
*RST; :CALC:LIM:CONT 1 GHZ, 2 GHZ
Define a limit line segment in the stimulus range between 1 GHz
and 2 GHz, using default response values.
CALC:LIM:CONT:SHIF 1; :CALC:LIM:CONT?
Shift the segment by 1 Hz. The modified limit line segment
ranges from 1000000001 (Hz) to 2000000001 (Hz).
Usage: Setting only
Manual operation: See "Shift Lines" on page 377
SCPI command reference
To Next Page
Loading...
