Specifications
SM 7-47 D014/D015/D078/D079
Specifications
S35 Rear Fence HP Sensor
Detects the actuator on the rear fence in the
tandem tray and switches off the rear fence
motor.
S36 Rear Fence Return Sensor
Detects the actuator on the rear fence in the
tandem tray and reverses the rear fence motor.
S37 Left Tray Paper Sensor
Detects the presence of paper in the left tray of
the tandem tray.
S38
Internal Temperature
Sensor
Located near the Y_PCU, this thermistor
monitors the internal temperature of the
machine.
S39 Waste Toner Lock Sensor
Signals an alert if the waste toner collection coil
locks and stops rotating.
S40 Duplex Transport Sensor 1
The feeler of this sensor detects the leading
edge and trailing edge of each sheet as it
passes from the jogger unit above and into the
horizontal feed path of the duplex unit below.
Signals a jam if the paper does not arrive at or
reach the sensor location at the prescribed time.
S41 Duplex Inverter Sensor
Detects the leading edge of the paper at the
inverter exit roller and signals to switch off the
reverse trigger roller solenoid to signal a jam if
the paper does not arrive at the prescribed time.
S42 Duplex Entrance Sensor
Detects paper jams at the entrance of the duplex
unit.
S43 Duplex Transport Sensor 3
Detects the leading edge and trailing edge of
each sheet as it passes from the jogger unit
above through the horizontal feed path of the
duplex unit below. Signals a jam if the paper
does not arrive at or reach the sensor location at
the prescribed time.
Rev. 04/2008
⇒
To Next Page
Loading...
