Installation
SM 13 D356
D356
Fax Option
Type C7500
8. Do either of these settings:
If one SG3 board is installed:
Do SP1104-23
Set Bit 1 of Communication Switch 16 to "1".
-or-
If two SG3 boards are installed:
Do SP1104-23
Set Bit 1 and Bit 3 of the Communication Switch 16 to "1".
9. Exit the SP mode.
10. Cycle the machine off/on.
11. Print out the system parameter list and confirm that "G3" is listed as an option.
12. Do the program settings required for PSTN-2 communication.
13. Keep the EMC address decal at the customer site (EU only).
To Next Page
Loading...
