Bit Switches
D356 74 SM
System Switch 05 - Not used (Do not change the factory settings.)
System Switch 06 (SP No. 1-101-007)
No Function Comments
0 to 7
Margin setting for Create
Margin Transmission
71 to 99 (BCD) %. This setting determines the
reduction ratio when the user uses the Create
Margin Transmission feature.
Default setting: 1001 0011 (93%)
System Switch 07 - Not used (Do not change the factory settings.)
System Switch 08 - Not used (Do not change the factory settings.)
System Switch 09 (SP No. 1-101-010)
No Function Comments
0
Addition of image data from
confidential transmissions on
the transmission result report
0: Disabled 1: Enabled
If this feature is enabled, the top half of the first
page of confidential messages will be printed
on transmission result reports.
1
Inclusion of communications on
the Journal when no image data
was exchanged.
0: Disabled 1: Enabled
0: Communications that reached phase C
(message tx/rx) of the T.30 protocol are listed
on the Journal.
1: Communications that reached phase A (call
setup) of T.30 protocol are listed on the
Journal. This will include telephone calls.
2
Automatic error report printout
0: Disabled 1: Enabled
0: Error reports will not be printed.
1: Error reports will be printed automatically
after failed communications.
3 Printing of the error code on the 1: Error codes are printed on the error reports.
To Next Page
Loading...
