Bit Switches
SM 75 D356
D356
Fax Option
Type C7500
System Switch 09 (SP No. 1-101-010)
No Function Comments
error report
0: No 1: Yes
4 Not used Do not change this setting.
5
Power failure report
0: Disabled 1: Enabled
1: A power failure report will be automatically
printed after the power is switched on if a fax
message disappeared from the memory when
the power was turned off last.
6
Conditions for printing the
protocol dump list
0: Print for all communications
1: Print only when there is a
communication error
This switch becomes effective only when
system switch 00 bit 6 is set to 1.
1: Set this bit to 1 when you wish to print a
protocol dump list only for communications with
errors.
7
Priority given to various types of
remote terminal ID when
printing reports
0: RTI > CSI > Dial label > Tel.
number
1: Dial label > Tel. number > RTI
> CSI
This bit determines which set of priorities the
machine uses when listing remote terminal
names on reports.
Dial Label: The name stored, by the user, for
the Quick/Speed Dial number.
To Next Page
Loading...
