PCU
SM 3-55 D014/D015/D078/D079
Replacement
Adjustment
6. Confirm that the neck of each bottle snaps and locks in place. Confirm that the neck of
each bottle is parallel with the top of each PCU.
7. To prevent the bottle from falling off, hold the bottle [B] with the left hand as shown, pull
the heat seal [A] out of the developer bottle and remove it.
8. Pull the seal from the developer bottle.
9. Make sure that you have removed the seal from the development bottle.
10. Gently tap the right side of each bottle to make sure that the developer flows freely.
11. Close the front door.
You must close the front door.
12. Turn the machine's power on.
To Next Page
Loading...
