Service Call Tables
SM 4-85 D014/D015/D078/D079
Trouble-
shooting
External controller error 5 *GW SC914
B
The external controller (Fiery) sends an
error message.
Turn the machine power
OFF/ON
External controller down *GW SC919
D
The EAC received an interrupt signal from
the FLUTE serial driver during print jobs in
progress and the connection between the
copier and external controller was broken.
Note: The EAC is the External Api
Converter.
Switch the machine OFF
and ON.
Printer error 1
An internal application error was detected and operation cannot
continue.
SC920
B
Software defective; turn the machine OFF/ON, or change the
controller firmware
Insufficient memory
Printer font error
A necessary font is not found in the SD card.
SC921 D
A necessary font is not found in the SD card.
The SD card data is corrupted.
⇒
⇒
Rev. 05/2008
To Next Page
Loading...
