Service Call Tables
D014/D015/D078/D079 4-86 SM
Net File function error *GW
SC925
B
The NetFile file management on the HDD cannot be used, or a NetFile
management file is corrupted and operation cannot continue. The HDDs
are defective and they cannot be debugged or partitioned, so the Scan
Router functions (delivery of received faxes, document capture, etc.),
Web services, and other network functions cannot be used.
HDD status codes are displayed below the SC code:
Refer to the four procedures below (Recovery from SC 925).
Here is a list of the HDD status codes:
Display Meaning
(-1) HDD not connected
(-2) HDD not ready
(-3) No label
(-4) Partition type incorrect
(-5) Error returned during label read or check
(-6) Error returned during label read or check
(-7) “filesystem” repair failed
(-8) “filesystem” mount failed
(-9) Drive does not answer command
(-10) Internal kernel error
(-11) Size of drive is too small
(-12) Specified partition does not exist
(-13) Device file does not exist
Rev. 05/2008
To Next Page
Loading...
