Ricoh D014 - Page 601

Group 2000
SM 5-59 D014/D015/D078/D079
Service
Tables
2302 Temp/Humid Disp
This SP displays the current temperature and humidity. These readings are output
by the temperature humidity display located on the bottom of the machine below
the used toner bottle.
1 Temp Disp
Room temperature (°C).
[0 to 100/ 0/1 deg.]
2 Rel Humidity Disp
Relative humidity (saturation point at current
temperature).
[0 to 100/0 /1 %rh.]
3 Abs Humidity Disp
Absolute humidity.
[0 to 63/ 0/ 0.01 g/m
3
]
4 Current Env Disp
Displays the current environment control mode. The
control modes are divided into 5 levels: LL, ML, MM, MH,
HH.
2303
Force Temp Corr DFU
Force Ambient Temperature Correction. The temperature/humidity sensor reading
is used to adjust settings during process control when this SP is set to zero (the
default). The value of the absolute humidity reading displayed by SP2302 003, as
well as the other readings of the conditions around the machine displayed with
SP2302, are used in the process control calculations. If you touch any key (1 to 6)
below, the value you select is used and the readings of the temperature/humidity
sensor are ignored.
Note: After you press any key (1 to 6), the setting you select remains in effect only
while the machine is in the SP mode. Once you leave the SP mode, this SP is reset
to zero automatically.
0: Sensor Detect
1: LLL
2: LL
3: ML
4: MM
5: MH
6: HH
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA