Group 5000
SM 5-203 D014/D015/D078/D079
Service
Tables
066
Job Spooling Clear: Start
Time
This SP determines whether the job interrupted
at power off is resumed at the next power on.
This SP operates only when SP5828-065 is set
to "1".
[0 to 1 / 1 / 1]
1: Resumes printing spooled jog.
0: Clears spooled job.
Job Spooling (Protocol)
This SP determines whether job spooling is
enabled or disabled for each protocol. This is a
8-bit setting.
[0 to 1 / 1 / 1]
0: No spooling, 1: Spooling enabled
0 LPR 4 BMLinks (Japan Only)
1 FTP (Not Used) 5 DIPRINT
2 IPP 6 Reserved (Not Used)
069
3 SMB 7 Reserved (Not Used)
090
TELNET
(0:OFF 1:ON)
Disables or enables Telnet operation. If this SP
is disabled, the Telnet port is closed.
[0 to 1 / 1 / 1]
0: Disable, 1: Enable
091
Web
(0:OFF 1:ON)
Disables or enables the Web operation.
[0 to 1 / 1 / 1]
0: Disable, 1: Enable
145
Active IPv6 Link Local
Address
This is the IPv6 local address referenced on the
Ethernet or wireless LAN (802.11) in the format:
"Link-Local address" + "Prefix Length"
The IPv6 address consists of a total 128 bits
configured in 8 blocks of 16 bits each. These
notations can be abbreviated. See "Note: IPV6
Addresses " below this table.
To Next Page
