R&S ZNB Series - Page 1154

Command reference
R&S
®
ZNB/ZNBT
1154User Manual 1173.9163.02 ─ 62
Usage: Setting only
Options: R&S ZNB/ZNBT-K20
Manual operation: See "User Specific" on page 700
MMEMory:LOAD:EYE:MASK <TraceName>, <TraceFile>
Loads a user-defined eye mask from a 7bit ASCII file.
Setting parameters:
<TraceName> Name of the related eye diagram
<TraceFile> String parameter containing the path and file name of the eye
mask file. If the path is omitted, the current directory is used (see
MMEMory:CDIRectory).
Usage: Setting only
Options: R&S ZNB/ZNBT-K20
Manual operation: See "Save / Load Mask Configuration" on page 707
MMEMory:LOAD:LIMit <TraceName>, <LimLineFile>[, <TouchstoneFile>[,
<StimulusOffset>[, <ResponseOffset>[, <LimLineType>]]]]
Loads a limit line definition from a specified file and assigns it to a trace with a speci-
fied name. Limit lines are created using the CALCulate<Ch>:LIMit... commands.
Note: Limit lines can be loaded from Touchstone files (*.s<n>p, where <n> denotes the
number of ports). The optional parameters '<TouchstoneFile>',
<StimulusOffset>, <ResponseOffset>, <LimLineType> are only relevant for
Touchstone files. For *.limit files, no optional parameters can be set.
Setting parameters:
<TraceName> Name of an existing trace in the active recall set (string parame-
ter). The imported limit line is assigned to this trace, irrespective
of the trace information in the limit line file.
<LimLineFile> String parameter to specify the name and directory of the limit
line file to be loaded. The default extension (manual control) for
limit line files is *.limit, although other extensions are allowed. If
no path is specified the analyzer searches the current directory,
to be queried with MMEMory:CDIRectory?. See also note on
Touchstone files above.
<TouchstoneFile> String parameter, selects an S-parameter from a Touchstone file.
The parameter must be compatible with the file type (e.g. for
one-port Touchstone files *.s1p, only the parameter name 'S11'
is allowed).
*RST: 'S11' (if all optional parameters are omitted)
SCPI command reference