R&S ZNB Series - Page 1203

Command reference
R&S
®
ZNB/ZNBT
1203User Manual 1173.9163.02 ─ 62
<KitLabel> String parameter containing the label of a calibration kit available
on the analyzer.
Example:
MMEM:LOAD:CKIT 'C:\Users\Public\
Documents\Rohde-Schwarz\Vna\
Calibration\Kits\New Kit 1 (123456).calkit'
Load the previously created cal kit file
New Kit 1 (123456).calkit from the default cal kit direc-
tory.
CORR:CKIT:LSEL 'N 50 Ohm', 'New Kit 1',
'123456'
Assign the imported kit to the N 50 Ω connector type, assuming
that the cal kit name stored in New Kit 1 (123456).calkit
reads New Kit 1 and that its label reads 123456.
[SENSe:]CORRection:CKIT:<ConnType>:LSELect <CalKitName>, <Label>
Selects the calibration kit to be used for a specified connector type <ConnType>. The
kit is identified by its name and label.
Tip: For connector types with arbitrary, user-defined names and labels you can use the
command [SENSe:]CORRection:CKIT:LSELect.
Suffix:
<ConnType>
.
Connector type, one of the following identifiers:
N50, N75 – N 50 Ω or N 75 Ω connectors
PC7, PC35, PC292 – PC 7, PC 3.5 or 2.92 mm connectors
USER<no> – user-defined connectors UserConn1, UserConn2
SMA – user-defined connector type SMA ...
Parameters:
<CalKitName> String parameter containing the name of a calibration kit availa-
ble on the analyzer. See "Cal kit naming conventions " under
[SENSe:]CORRection:CKIT:<ConnType>:LSELect.
*RST: n/a (A *RST does not change the assignment
between connector types and calibration kits.)
<CalKitLabel> String parameter containing the label of a calibration kit available
on the analyzer, usually the serial number.
*RST: n/a (A *RST does not change the assignment
between connector types and calibration kits.)
SCPI command reference