R&S ZNB Series - Page 1318

Command reference
R&S
®
ZNB/ZNBT
1318User Manual 1173.9163.02 ─ 62
Example:
SEGM:ADD
Create a new sweep segment no. 1 in channel no. 1.
SEGM:SWE:TIME 0.1
Increase the segment sweep time to 0.1 s.
SEGM:SWE:TIME:SUM?
Query the total duration of the segmented sweep. The response
is 0.1, because there is only one sweep segment.
Manual operation: See "Optional Columns" on page 435
[SENSe<Ch>:]SEGMent<Seg>:SWEep:TIME:CONTrol <Boolean>
Selects common or independent "Segment Sweep Time" settings for the sweep seg-
ments.
Suffix:
<Ch>
.
Channel number
<Seg> Sweep segment number. This suffix is ignored; the command
controls the whole segmented sweep.
Parameters:
<Boolean> ON – use independent segment sweep time settings, to be
defined via [SENSe<Ch>:]SEGMent<Seg>:SWEep:TIME.
OFF – reset the segment sweep time in all sweep segments to
the segment sweep time for unsegmented sweeps, defined via
[SENSe<Ch>:]SWEep:TIME. ON will not restore the previous
values.
The parameter is automatically switched to ON when a segment
sweep time is entered using [SENSe<Ch>:]SEGMent<Seg>:
SWEep:TIME or if the channel settings in a sweep segment
require a sweep time larger than the unsegmented sweep time.
*RST: OFF
Example:
SEGM:ADD
Create a new sweep segment no. 1 in channel no. 1.
SEGM:SWE:TIME 0.1
Increase the segment sweep time to 0.1 s.
SEGM:SWE:TIME:CONT OFF
Couple the sweep times in all segments and reset the sweep
time in segment no. 1 to the initial value.
Manual operation: See "Optional Columns" on page 435
[SENSe<Ch>:]SEGMent<Seg>:SWEep:TIME:SUM?
Returns the total duration of the segmented sweep, calculated as the sum of the
sweep times of the individual segments ([SENSe<Ch>:]SEGMent<Seg>:SWEep:
TIME).
Suffix:
<Ch>
.
Channel number.
SCPI command reference