R&S ZNB Series - Page 1397

Command reference
R&S
®
ZNB/ZNBT
1397User Manual 1173.9163.02 ─ 62
SYSTem:COMMunicate:RDEVice:GENerator<Gen>:SEPower <Power>
Defines the external generator power value after the end of a sweep. The setting is rel-
evant if the generator is switched to a user-selected power; see example.
Suffix:
<Gen>
.
Generator number
Parameters:
<Power> End power
Range: -145 dBm to +30 dBm
*RST: 0 dBm
Default unit: dBm
Example:
SYSTem:COMMunicate:RDEVice:GENerator:SEPMode
USER
Switch the generator to a user-selected power value after the
sweep is terminated.
SYSTem:COMMunicate:RDEVice:GENerator:SEPower
-10
Define a end power of -10 dBm.
Manual operation: See "Configured Devices" on page 787
SYSTem:COMMunicate:RDEVice:PMETer<Pmtr>:AZERo
Starts auto zeroing of the external power meter.
Suffix:
<Pmtr>
.
Number of the configured power meter. Power meters must be
numbered in ascending order, starting with 1. If a number is re-
used, the previous power meter configuration is overwritten.
Power meters can be assigned several times so that the number
of configured power meters is practically unlimited.
Usage: Event
Manual operation: See "Auto Zero" on page 314
SYSTem:COMMunicate:RDEVice:PMETer:CATalog?
Queries the numbers of all configured external power meters. The response is a string
containing a comma-separated list of power meter numbers.
SCPI command reference