R&S ZNB Series - Page 1457

Command reference
R&S
®
ZNB/ZNBT
1457User Manual 1173.9163.02 ─ 62
Example: //Create a custom utilization
DIAG:HUMS:UTIL:CUST:ADD
1,"TrackingSomething","This utilization tracks
something","Hz",1
//Set an initial absolute value for the utilization with ID = 1; initial
start value = 0
DIAG:HUMS:UTIL:CUST:UPD 1,25,abs
//Upon an event, the utilization changes its value each time the
event occurs
DIAG:HUMS:UTIL:CUST:UPD 1,5,incr
//New value = 30, new start value = 25
//Another event
DIAG:HUMS:UTIL:CUST:UPD 1,5,incr
//New value = 35, new start value = 30 etc.
//Query all available custom utilizations
DIAG:HUMS:UTIL:CUST:ALL
//Delete the custom utilization with ID = 1
DIAG:HUMS:UTIL:CUST:DEL 1
//Delete all custom utilizations
DIAG:HUMS:UTIL:CUST:DEL:ALL
Usage:
Setting only
DIAGnostic:HUMS:UTILization:CUSTom:ALL?
Queries all custom utilizations currently in use.
Return values:
<block_data> String returns REST endpoints as block data in a comma-sepa-
rated list.
Binary block data with the following syntax:
#<Digits><Length><Binarydata>
#
Indicates the start of the binary block
<Digits>
Decimal value
Gives the number of decimal digits used for the <Length>
value
<Length>
Decimal value
Number of bytes the follow in the <Binary data> part
<Binary data>
Binary data in ASCII format
Example:
See DIAGnostic:HUMS:UTILization:CUSTom:ADD
Usage: Query only
DIAGnostic:HUMS:UTILization:CUSTom:DELete <ID>
Deletes a single custom utilization.
HUMS and service date commands