GUI reference
R&S
®
ZNB/ZNBT
486User Manual 1173.9163.02 ─ 62
Characterization
See "Characterization" on page 451.
Temperature Compensation
Available for inline calibration systems (ICS) only. Applies to all inline calibration units
(ICUs) that are connected to the ICS and that are used with factory characterization
data.
If checked, the R&S ZNB/ZNBT firmware adjusts the factory characterization data
according to the ICU temperatures.
Remote command:
[SENSe<Ch>:]CORRection:COLLect:AUTO:TEMPcomp
Calibration Type
Selects the calibration type for the selected physical ports. For an overview, refer to
Chapter 4.5.7.2, "Calibration types", on page 200. The calibration types PUOSM and
PTOSM are compatible with all port combinations.
Remote command:
[SENSe<Ch>:]CORRection:COLLect:AUTO:TYPE
[SENSe<Ch>:]CORRection:COLLect:AUTO:PORTs:TYPE
[SENSe<Ch>:]CORRection:COLLect:AUTO:CONFigure
Power Meter
Shows a list of all power meters that have been properly configured and are available
for the scalar source power calibration of a single source port. The last configured
power meter is selected by default. See "Configured Devices" on page 782.
Remote command:
[SENSe:]CORRection:COLLect:PMETer:ID
Power Port
Selects the port for the scalar source power calibration.
Source leveling
If checked, the "SMARTerCal" wizard opens the Power Cal wizard on completion.
There you can perform a complementary source flatness calibration at the ""SMARTer-
Cal"ibrated" ports, and additional scalar power calibrations at other ports.
Select All/Deselect All
Selects/deselects all ports.
These buttons are only shown if more than 4 ports are available.
Next
Proceeds to Step 2: Connections. Next is unavailable (and a warning is displayed) if
the following happens:
●
Fewer than two ports have been selected.
●
The selected characterization data do not cover all the ports to be calibrated.
●
The selected characterization data do not contain all standards needed for the
selected calibration type.
Cal softtool
To Next Page
Loading...
Need help?
General
