R&S ZNB Series User Manual

GUI reference
R&S
®
ZNB/ZNBT
539User Manual 1173.9163.02 ─ 62
METAS calibration using calibration units is not supported.
Start Verification
While a METAS calibration is active, this button opens the METAS Verification dialog.
Save Measurement
Allows you to save the current measurement results to the temporary METAS VNA
Tools project that is created under the hood during the METAS calibration. This project
can be saved using the Export Data to METAS VNA Tools function.
Opens the "Measurement Filename" dialog that lets you specify a prefix for the name
of the generated file. A timestamp of the related measurement is always appended.
If no measurement data are available, the firmware displays a message box instead of
the "Measurement Filename" dialog:
Export Data to METAS VNA Tools
Saves the current state of the METAS VNA Tools project that is created with the
METAS calibration.
Cal softtool

R&S ZNB Series Specifications

General

Brand	R&S
Model	ZNB Series
Category	Measuring Instruments
Language	English