R&S ZNB Series - Page 659

GUI reference
R&S
®
ZNB/ZNBT
659User Manual 1173.9163.02 ─ 62
Depending on the selected DUT, a different set of test coupon types is supported.
Test coupon "Sym 2x Thru" "1x Open" "1x Short" "1x Open, 1x
Short"
ISD
☑ ☑ ☑ ☑
SFD
☑ ☑ ☑

EZD
☑
  
Depending on the selected test coupon type, the number of logical ports and the
graphical representation changes:
Test coupon type Single-ended Balanced
"Sym 2x Thru"
"1x Open"
"1x Short"
Use the Balanced Ports dialog to create the single ended and balanced ports that are
required for the measurements.
There are several rules to be considered with the coupon measurement interface.
●
The port selection drop-down allows you to select from any available port of the
correct type on the instrument.
Offset Embed softtool