R&S ZNB Series - Page 869

To Next Page

To Previous Page

Command reference

R&S

ZNB/ZNBT

869User Manual 1173.9163.02 ─ 62

Manual operation: See "Active" on page 699

CALCulate<Chn>:EYE:JITTer:TYPE:DIRac <Boolean>

Enables/disables Dirac jitter insertion in the generator simulation of the related eye dia-

gram.

This command will raise an execution error if the active trace in the selected channel is

not an eye diagram.

Amplitude and probability of the jitter can be specified using CALCulate<Chn>:EYE:

JITTer:DIRac:DELTa and CALCulate<Chn>:EYE:JITTer:DIRac:

PROBability, respectively.

Note that jitter will not be applied unless the jitter functionality is activated using

CALCulate<Chn>:EYE:JITTer:STATe.

Suffix:

<Chn>

Channel number used to identify the active trace

Parameters:

<Boolean> *RST: OFF

Options: R&S ZNB/ZNBT-K20

Manual operation: See "Dirac" on page 700

CALCulate<Chn>:EYE:JITTer:TYPE:PERiodic <Boolean>

Enables/disables periodic jitter insertion in the generator simulation of the related eye

diagram.

This command will raise an execution error if the active trace in the selected channel is

not an eye diagram.

Amplitude, frequency and phase of the jitter can be specified using

CALCulate<Chn>:EYE:JITTer:PERiodic:MAGNitude, CALCulate<Chn>:EYE:

JITTer:PERiodic:FREQuency and CALCulate<Chn>:EYE:JITTer:PERiodic:

PHASe, respectively.