Group 2000
D014/D015/D078/D079 5-68 SM
2422 LEdge SWT:Norm K
Leading Edge Switch Timing for Plain Paper: K. Sets the switch off timing
SP2421. The value selected is the number of mm from the leading edge of the
paper. These settings 1) apply only to black printing on plain paper at full speed
(even when full-color is selected), and 2) apply to both sides of a duplex page.
2 PTR
3 SepDC
4 SepAC
[0 to 30/1 mm]
2423 TEdgeCor:Norm K
Trailing Edge Correction for Plain Paper: K. This SP sets the coefficient used to
correct bias at image to paper transfer for each side of the paper. These
settings are applied to the trailing edge for black printing on plain paper at full
speed and apply to black, even when printing in full color mode.
7 Side1:PTR
12 Side2:PTR
[0 to 250/1%]
2424 TEdgeSWT:Norm K PTR
Trailing Edge Switch Timing for Plain Paper: K. This setting sets the start timing for
application of SP2423 at the trailing edge of each sheet (Side 1, Side 2). This
setting is applied to the trailing edge for black printing on plain paper at full speed
and apply to black, even when printing in full color mode.
[-100 to 0/1 mm]
The mm distance is measured away from the trailing edge of the image.
To Next Page
Loading...
