Group 2000
SM 5-69 D014/D015/D078/D079
Service
Tables
2426 LEdgeCor:Norm FC
Leading Edge Correction for Plain Paper: FC. This SP sets the coefficient used to
1) correct bias at the leading edge for full-color image transfer (ITB) bias at image
to paper transfer when using plain paper, and 3) correct the dc and ac voltages
applied at paper separation.
Notes: These settings apply:
Only the distance from the leading edge set with SP2427.
Only to full color printing on plain paper at full speed.
7 Side1:PTR
8 Side1:SepDC
9 Side1:SepAC
12 Side2:PTR
13 Side2:SepDC
14 Side2:SepAC
[0 to 250/1%]
2427 LEdgeSWT:Norm FC
Leading Edge Switch Timing for Plain Paper: FC. This SP sets switch timing that
sets the distance from the leading edge where the settings of SP2426 are to
apply. The value selected is the number of mm from the leading edge of the
paper. These settings 1) apply only full-color printing on plain paper at full speed,
and 2) apply to both sides of a duplex page.
2 PTR [0 to 30/1 mm]
3 SepDC [0 to 30/1 mm]
4 SepAC [0 to 30/1 mm]
To Next Page
Loading...
