Group 2000
D014/D015/D078/D079 5-70 SM
2428 TEdgeCor:Norm FC
Trailing Edge Correction for Plain Paper: FC. This SP sets the coefficient used to
correct bias at image to paper transfer for each side of the paper. These settings
are applied to the trailing edge for full-color printing on plain paper at full speed as
far as where SP2429 takes effect.
7 Side1:PTR
012 Side2:PTR
[0 to 250/1%]
2429 TEdgeSWT:Norm FC – PTR
Switch Timing for Plain Paper: FC. This setting sets the start timing for application
of SP2428 007, 2428 012 at the trailing edge of each sheet (Side 1, Side 2). These
settings are applied to the trailing edge for black printing on plain paper at full
speed and apply to black, even when printing in full color mode.
[-100 to 0/1 mm]
The mm distance is measured away from the trailing edge of the image.
2430 Norm:K:LLL Plain Paper: K Very Low
2431 Norm:K:LL Plain Paper: K Low
2432 Norm:K:ML Plain Paper: K Medium Low
2433 Norm:K:MM Plain Paper: K Medium
2434 Norm:K:MH Plain Paper: K Medium High
2435 Norm:K:HH Plain Paper: K High
These SPs set the paper size correction coefficient for the image to paper
transfer bias threshold values calculated based on the reading of the absolute
humidity from the temperature/humidity sensor and the thresholds set with
SP2304.
To Next Page
Loading...
