Group 2000
D014/D015/D078/D079 5-76 SM
2776 LEdge Cor:Sp1 FC
Leading Edge Correction for Special Paper 1: FC.
These SPs do the following settings when printing on Special Paper 1 in the
full-color mode:
1) ITB: Sets strength/timing of the correction coefficient for the application of bias
when the image is transferred from the drum to the ITB.
2) PTR: Sets the strength/timing of the correction coefficient for the application of
bias when the image is transferred from ITB.
3) SepDC, SepAC: Set the strength/timing of the dc and ac charges applied to
neutralize the charges on the belt and paper so they will separate more easily.
Note: SP2776 selects the strength of the bias coefficient, and SP2777 sets the
start timing of the bias application.
7 Side1:PTR
8 Side1:SepDC
9 Side1:SepAC
12 Side2:PTR
13 Side2:SepDC
14 Side2:SepAC
[0 to 250/ 1%]
2777 LEdge SWT:Sp1 FC
Leading Edge Switch Timing for Special Paper 1: FC. Sets the switch off timing of
SP2776. The selected value is the number of mm from the leading edge. Applies
only to printing in full-color mode on Special Paper 1.
2 PTR
3 SepDC
4 SepAC
[0 to 30/1 mm]
To Next Page
Loading...
